[RFC] S3C24xx: Enable only the clocks of used units

Jean-Christophe PLAGNIOL-VILLARD plagnioj at jcrosoft.com
Tue Oct 19 04:27:28 EDT 2010


On 08:55 Tue 19 Oct     , Juergen Beisert wrote:
> Jean-Christophe PLAGNIOL-VILLARD wrote:
> > > -	mov r1, #0xFFFFFFF0
> > > +	/*
> > > +	 * Disable the clocks for most devices on this chip.
> > > +	 * They will be enabled again on demand
> > > +	 */
> > > +#ifdef CONFIG_S3C24XX_NAND_BOOT
> > > +	ldr r1, =0x6010 /* (CLK_RTC | CLK_GPIO | CLK_NAND) */
> > > +#else
> > > +	mov r1, #0x6000 /* (CLK_RTC | CLK_GPIO) */
> >
> > how about use the macro and define a macro to avoid the ifdef
> 
> I tried with macros, but the assembler failed. Can't remember why. But I tried 
> again a few minutes ago .... and now it works (????).
make because you had c definition in the header?
> 
> Do you mean something like this instead?
> 
> [...]
> #ifdef CONFIG_S3C24XX_NAND_BOOT
> # define FORCED_CLOCKS (CLK_RTC | CLK_GPIO | CLK_NAND)
> #else
> # define FORCED_CLOCKS (CLK_RTC | CLK_GPIO)
> #endif
> 
> 	/*
> 	 * Disable the clocks for most devices on this chip.
> 	 * They will be enabled again on demand
> 	 */
> 	ldr r1, =FORCED_CLOCKS
yeah excalty

Best Regards,
J.



More information about the barebox mailing list