[PATCH 5/7 V3] netx/kconfig: inverse the board selection

[Jean-Christophe PLAGNIOL-VILLARD]

instead of select first the board which will select the arch, now
first choice the arch to filter the possible boards

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
---
 arch/arm/Kconfig           |   15 ---------------
 arch/arm/mach-netx/Kconfig |   17 +++++++++++++++++
 2 files changed, 17 insertions(+), 15 deletions(-)

diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index 8271465..74cb595 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -96,21 +96,6 @@ config ARCH_S3C24xx
 
 endchoice
 
-choice
-	prompt "Select your board"
-	depends on !ARCH_AT91 && !ARCH_AT91RM9200 && !ARCH_OMAP && !ARCH_IMX && !ARCH_S3C24xx
-
-config MACH_NXDB500
-	bool "Hilscher Netx nxdb500"
-	depends on ARCH_NETX
-	select HAS_NETX_ETHER
-	select HAS_CFI
-	select MACH_HAS_LOWLEVEL_INIT
-	help
-	  Say Y here if you are using the Hilscher Netx nxdb500 board
-
-endchoice
-
 source arch/arm/mach-at91/Kconfig
 source arch/arm/mach-at91rm9200/Kconfig
 source arch/arm/mach-imx/Kconfig
diff --git a/arch/arm/mach-netx/Kconfig b/arch/arm/mach-netx/Kconfig
index a058470..a62c3bc 100644
--- a/arch/arm/mach-netx/Kconfig
+++ b/arch/arm/mach-netx/Kconfig
@@ -1,3 +1,5 @@
+if ARCH_NETX
+
 config NETX_SDRAM_CTRL
 	hex
 	default 0x010D0001 if MACH_NXDKN
@@ -30,3 +32,18 @@ config NETX_COOKIE
 	default 16 if MACH_NXEB500HMI
 	default 16 if MACH_NXHX
 
+choice
+
+	prompt "Netx Board Type"
+
+config MACH_NXDB500
+	bool "Hilscher Netx nxdb500"
+	select HAS_NETX_ETHER
+	select HAS_CFI
+	select MACH_HAS_LOWLEVEL_INIT
+	help
+	  Say Y here if you are using the Hilscher Netx nxdb500 board
+
+endchoice
+
+endif
-- 
1.6.5