Is this card supported?
ikorot at earthlink.net
ikorot at earthlink.net
Sun Sep 26 23:55:03 EDT 2010
Hi,
-----Original Message-----
>From: Gábor Stefanik <netrolller.3d at gmail.com>
>Sent: Sep 25, 2010 6:23 PM
>To: ikorot at earthlink.net
>Cc: Rafał Miłecki <zajec5 at gmail.com>, b43-dev at lists.infradead.org
>Subject: Re: Is this card supported?
>
>2010/9/25 <ikorot at earthlink.net>:
>> Rafal,
>>
>>
>> -----Original Message-----
>>>From: Rafał Miłecki <zajec5 at gmail.com>
>>>Sent: Sep 24, 2010 2:27 PM
>>>To: ikorot at earthlink.net
>>>Cc: b43-dev at lists.infradead.org
>>>Subject: Re: Is this card supported?
>>>
>>>2010/9/24 <ikorot at earthlink.net>:
>>>> Hi, ALL,
>>>> This is an information about the hardware:
>>>>
>>>> IgorsGentooWork OE # uname -a
>>>> Linux IgorsGentooWork 2.6.32-gentoo-r7 #4 Mon Jul 5 13:42:27 PDT 2010 i686 Intel(R) Celeron(R) M processor 1.50GHz GenuineIntel GNU/Linux
>>>>
>>>> IgorsGentooWork OE # lspci -vnn | grep 14e4
>>>> 02:00.0 Ethernet controller [0200]: Broadcom Corporation BCM4401-B0 100Base-TX [14e4:170c] (rev 02)
>>>> 02:03.0 Network controller [0280]: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller [14e4:4318] (rev 02)
>>>>
>>>> Is this device supported?
>>>
>>>http://wireless.kernel.org/en/users/Drivers/b43
>>
>> Can you then explain this:
>>
>> IgorsGentooWork OE # ifconfig wlan0 up
>> IgorsGentooWork OE # iwconfig wlan0 essid "GoogleWiFi"
>> Cannot read /proc/net/wireless
>
>Let me guess: procfs is not mounted.
You guessed wrong: procfs is mounted:
/dev/hda3 on / type ext3 (rw,noatime)
proc on /proc type proc (rw,nosuid,nodev,noexec,relatime)
sysfs on /sys type sysfs (rw,nosuid,nodev,noexec,relatime)
udev on /dev type tmpfs (rw,nosuid,relatime,size=10240k,mode=755)
devpts on /dev/pts type devpts (rw,nosuid,noexec,relatime,gid=5,mode=620)
shm on /dev/shm type tmpfs (rw,noexec,nosuid,nodev)
usbfs on /proc/bus/usb type usbfs (rw,noexec,nosuid,devmode=0664,devgid=85)
binfmt_misc on /proc/sys/fs/binfmt_misc type binfmt_misc (rw,noexec,nosuid,nodev)
Any other ideas?
Thank you.
>
>> Error for wireless request "Set ESSID" (8B1A) :
>> SET failed on device wlan0 ; Invalid argument.
>> IgorsGentooWork OE # man iwconfig
>> IgorsGentooWork OE # iwconfig wlan0 scan
>> iwconfig: unknown command "scan"
>> IgorsGentooWork OE # ifconfig wlan0 scan
>> scan: Unknown host
>> ifconfig: `--help' gives usage information.
>> IgorsGentooWork OE # man ifconfig
>> IgorsGentooWork OE # ifconfig -a
>> eth0 Link encap:Ethernet HWaddr 00:14:22:aa:cc:69
>> inet addr:192.168.2.141 Bcast:192.168.2.255 Mask:255.255.255.0
>> inet6 addr: fe80::214:22ff:feaa:cc69/64 Scope:Link
>> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
>> RX packets:2403559 errors:0 dropped:0 overruns:0 frame:0
>> TX packets:2084228 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 txqueuelen:1000
>> RX bytes:2352559614 (2.1 GiB) TX bytes:766927573 (731.3 MiB)
>> Interrupt:9
>>
>> lo Link encap:Local Loopback
>> inet addr:127.0.0.1 Mask:255.0.0.0
>> inet6 addr: ::1/128 Scope:Host
>> UP LOOPBACK RUNNING MTU:16436 Metric:1
>> RX packets:28 errors:0 dropped:0 overruns:0 frame:0
>> TX packets:28 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 txqueuelen:0
>> RX bytes:2592 (2.5 KiB) TX bytes:2592 (2.5 KiB)
>>
>> sit0 Link encap:IPv6-in-IPv4
>> NOARP MTU:1480 Metric:1
>> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 txqueuelen:0
>> RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
>>
>> wlan0 Link encap:Ethernet HWaddr 00:16:ce:1d:9f:32
>> UP BROADCAST MULTICAST MTU:1500 Metric:1
>> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>> collisions:0 txqueuelen:1000
>> RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
>>
>> dmesg says:
>>
>> IgorsGentooWork OE # dmesg | tail
>> [4995866.378984] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw
>> [4995866.379706] PM: Adding info for No Bus:ssb0:0
>> [4995866.407533] PM: Removing info for No Bus:ssb0:0
>> [4995866.534044] b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
>> [4995866.566088] b43-phy0 debug: Chip initialized
>> [4995866.566283] b43-phy0 debug: 32-bit DMA initialized
>> [4995866.566357] b43-phy0 debug: QoS enabled
>> [4995866.577067] b43-phy0 debug: Wireless interface started
>> [4995866.577076] b43-phy0 debug: Adding Interface type 2
>> [4995866.577633] ADDRCONF(NETDEV_UP): wlan0: link is not ready
>>
>> Thank you.
>>
>> P.S.: Just so that nobody will be bothered I will add the ML to
>> whitelist.. ;-)
>>
>>>
>>>--
>>>Rafał
>>
>>
>> _______________________________________________
>> b43-dev mailing list
>> b43-dev at lists.infradead.org
>> http://lists.infradead.org/mailman/listinfo/b43-dev
>>
>
>
>
>--
>Vista: [V]iruses, [I]ntruders, [S]pyware, [T]rojans and [A]dware. :-)
More information about the b43-dev
mailing list