[PATCH] b43: rfkill: use status register based on core revision not (PHY's)

Larry Finger Larry.Finger at lwfinger.net
Fri Oct 22 17:38:05 EDT 2010


On 10/22/2010 03:24 PM, Rafał Miłecki wrote:
> Signed-off-by: Rafał Miłecki <zajec5 at gmail.com>
> ---
> This makes my N-PHY radio at least running (no scanning results so far). The
> same register is used by wl on this device.
> ---
>  drivers/net/wireless/b43/rfkill.c |    2 +-
>  1 files changed, 1 insertions(+), 1 deletions(-)
> 
> diff --git a/drivers/net/wireless/b43/rfkill.c b/drivers/net/wireless/b43/rfkill.c
> index 78016ae..d2734c9 100644
> --- a/drivers/net/wireless/b43/rfkill.c
> +++ b/drivers/net/wireless/b43/rfkill.c
> @@ -28,7 +28,7 @@
>  /* Returns TRUE, if the radio is enabled in hardware. */
>  bool b43_is_hw_radio_enabled(struct b43_wldev *dev)
>  {
> -	if (dev->phy.rev >= 3 || dev->phy.type == B43_PHYTYPE_LP) {
> +	if (dev->dev->id.revision >= 3) {
>  		if (!(b43_read32(dev, B43_MMIO_RADIO_HWENABLED_HI)
>  		      & B43_MMIO_RADIO_HWENABLED_HI_MASK))
>  			return 

As that register is present only when the core revision >= 3, this change should
not cause a regression. Perhaps this was an error in the RE from the start and
testing the phy.rev has always been wrong.

John: Just in case my analysis is wrong, keep this change out of 2.6.37. I'll
give it some testing with G PHYs before 2.6.38 merge time.

Larry



More information about the b43-dev mailing list