BCM4318KFBG not recognized by b43

[Daniel Klaffenbach]

Hi,

On Thursday 18 November 2010 00:10:23 Rafał Miłecki wrote:
> Would be nice. I was afraid compiling kernel for OpenWRT won't be
> easy/fast.
I've recompiled the latest OpenWRT trunk. I did turn on debugging symbols and 
I've also applied the patch I did send earlier and to my surprise the module 
loded without any complaints. dmesg gave me the following message:

b43-phy0: Broadcom 4318 WLAN found (core revision 9)
ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
Registered led device: b43-phy0::tx
Registered led device: b43-phy0::rx
Registered led device: b43-phy0::radio
Broadcom 43xx driver loaded [ Features: PL, GPIO LED Mask: 0x000f,
Firmware-ID: FW13 ]
b43 ssb1:0: firmware: requesting b43/ucode5.fw
b43 ssb1:0: firmware: requesting b43/pcm5.fw
b43 ssb1:0: firmware: requesting b43/b0g0initvals5.fw
b43 ssb1:0: firmware: requesting b43/b0g0bsinitvals5.fw
b43-phy0: Loading firmware version 478.104 (2008-07-01 00:50:23)

After doing some basic testing I can confirm that the card is working! I do not 
know why it did give me the errors the last time, but I also did a nvram reset 
of the box today - maybe that did the trick.

It would be nice if you could review my changes to 
drivers/ssb/b43_pci_bridge.c and include/linux/pci_ids.h and add the vendor id 
upstream.


Regards,
Daniel
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 198 bytes
Desc: This is a digitally signed message part.
URL: <http://lists.infradead.org/pipermail/b43-dev/attachments/20101119/3ee0c1d3/attachment.sig>