[PATCH] ath6kl: use WMI to set RSN capabilities

[Kalle Valo]

Alfonso Sanchez-Beato <alfonso.sanchez-beato at canonical.com> writes:

> On Fri, Apr 13, 2018 at 12:48 PM, Kalle Valo <kvalo at qca.qualcomm.com> wrote:
>>
>> Alfonso Sánchez-Beato <alfonso.sanchez-beato at canonical.com> writes:
>>
>> > This fixes AP mode when the ATH6KL_FW_CAPABILITY_RSN_CAP_OVERRIDE flag
>> > is not present in the FW. The id of some WMI commands is also fixed
>> > (there was an error in the enum order), and a function to set RSN caps
>> > is added.
>> >
>> > Signed-off-by: Alfonso Sánchez-Beato <alfonso.sanchez-beato at canonical.com>
>>
>> What hardware and firmware version? Do note that ids can change between
>> ath6kl firmware branches so even if it works for you it might break some
>> other branch. That's why it's good to document the setup in the commit
>> log.
>
> I have tested this in an Atheros QCA6234. kmsg shows this about the fw:
>
> ath6kl: ar6004 hw 3.0 sdio fw 3.5.0.604 api 1

Ok, I'll add this to the commit log.

-- 
Kalle Valo