AR6003 concurrent AP+STA

[Attila Sukosd]

Hi Nick,

Did you have some success with this?
Looking to do the same here too.

Cheers,
Attila

On Wed, Dec 17, 2014 at 8:52 PM, Stevens, Nick
<Nick.Stevens at etherios.com> wrote:
> Hi all,
>
> I am attempting to use an AR6003 in a concurrent AP/station mode. Using the iw tool to try and add a second virtual interface gives me the following error:
>   > iw phy phy0 interface add wlan0_ap type __ap
>     ath6kl: Not a supported interface type
>
> I get the same thing for "managed" and "station" types.
>
> I've traced the error back into the kernel to a check against available VIFs. It seems that the driver is being loaded with "1" for the max_vif's, which is strange since I know this device supports AP+STA.
>
> In short - can anyone provide any information about putting the AR6003 into concurrent AP+STA mode? Is this even possible with the in-kernel firmware and driver?
>
> Nick Stevens
>
>
>
>
> _______________________________________________
> ath6kl mailing list
> ath6kl at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/ath6kl



-- 
Attila Sukosd
CTO & Co-founder
+45 27 14 88 03
attila at airtame.com
LinkedIn
GitHub
________________________________

AIRTAME ApS
Vestergade 20C, 2nd Floor
1456 Copenhagen
Denmark
airtame.com
Facebook
LinkedIn
Twitter