[PATCH v5 14/16] wifi: ath12k: Switch to generic PAS TZ APIs

[Jeff Johnson]

On 5/5/2026 7:27 AM, Jeff Johnson wrote:
> On 5/4/2026 6:06 AM, Sumit Garg wrote:
>> @@ -485,9 +485,9 @@ static void ath12k_ahb_power_down(struct ath12k_base *ab, bool is_suspend)
>>  		pasid = (u32_encode_bits(ab_ahb->userpd_id, ATH12K_USERPD_ID_MASK)) |
>>  			 ATH12K_AHB_UPD_SWID;
>>  		/* Release the firmware */
>> -		ret = qcom_scm_pas_shutdown(pasid);
>> +		ret = qcom_pas_shutdown(pasid);
>>  		if (ret)
>> -			ath12k_err(ab, "scm pas shutdown failed for userPD%d\n",
>> +			ath12k_err(ab, "pas shutdown failed for userPD%d: %d\n",
>>  				   ab_ahb->userpd_id);
> 
> at some point the "ret" param was dropped, and this now generates build warnings
The 'ret' param was dropped by:
8fb66931fe31 ("wifi: ath12k: Enable IPQ5424 WiFi device support")

Not sure if that was on purpose or accidental. Sowmiya?

-       if (ret)
-               ath12k_err(ab, "scm pas shutdown failed for userPD%d: %d\n",
-                          ab_ahb->userpd_id, ret);
...
+               if (ret)
+                       ath12k_err(ab, "scm pas shutdown failed for userPD%d\n",
+                                  ab_ahb->userpd_id);