[PATCH v8 07/14] remoteproc: qcom: Select QCOM_PAS generic service

[Sumit Garg]

Hi Konrad,

On Tue, Jun 30, 2026 at 02:37:59PM +0200, Konrad Dybcio wrote:
> On 6/26/26 3:34 PM, Sumit Garg wrote:
> > From: Sumit Garg <sumit.garg at oss.qualcomm.com>
> > 
> > Select PAS generic service driver to enable support for multiple PAS
> > backends like OP-TEE in addition to SCM.
> > 
> > Tested-by: Mukesh Ojha <mukesh.ojha at oss.qualcomm.com> # Lemans
> > Tested-by: Vignesh Viswanathan <vignesh.viswanathan at oss.qualcomm.com> # IPQ9650
> > Signed-off-by: Sumit Garg <sumit.garg at oss.qualcomm.com>
> > ---
> >  drivers/remoteproc/Kconfig | 4 +++-
> >  1 file changed, 3 insertions(+), 1 deletion(-)
> > 
> > diff --git a/drivers/remoteproc/Kconfig b/drivers/remoteproc/Kconfig
> > index c521c744e7db..65befdbfa5f7 100644
> > --- a/drivers/remoteproc/Kconfig
> > +++ b/drivers/remoteproc/Kconfig
> > @@ -210,6 +210,7 @@ config QCOM_Q6V5_MSS
> >  	select QCOM_Q6V5_COMMON
> >  	select QCOM_RPROC_COMMON
> >  	select QCOM_SCM
> > +	select QCOM_PAS
> 
> This is a NOP, SCM already requires QCOM_PAS

That's true but I think we should rather have explicit modules
dependencies whose APIs are being used by their clients. QCOM_SCM is a
special module in this case exporting direct SCM calls apart from being
the backend for the PAS service.

I would prefer explicit dependencies but let me know if you feel
strongly otherwise.

> 
> >  	help
> >  	  Say y here to support the Qualcomm self-authenticating modem
> >  	  subsystem based on Hexagon V5. The TrustZone based system is
> > @@ -230,6 +231,7 @@ config QCOM_Q6V5_PAS
> >  	select QCOM_Q6V5_COMMON
> >  	select QCOM_RPROC_COMMON
> >  	select QCOM_SCM
> > +	select QCOM_PAS
> 
> Likewise
> 
> >  	help
> >  	  Say y here to support the TrustZone based Peripheral Image Loader for
> >  	  the Qualcomm remote processors. This is commonly used to control
> > @@ -282,7 +284,7 @@ config QCOM_WCNSS_PIL
> >  	select QCOM_MDT_LOADER
> >  	select QCOM_PIL_INFO
> >  	select QCOM_RPROC_COMMON
> > -	select QCOM_SCM
> > +	select QCOM_PAS
> 
> This is OK
> 
> _however_
> 
> It leads to a situation where no back-ends can be enabled

The TEE backend is enabled by default if ARCH_QCOM is enabled, if you
agree then we can similarly enable SCM backend too.

-Sumit