[PATCH] dt-bindings: wireless: ath12k: allow calibration variant for WCN7850

[Ernest Van Hoecke]

On Thu, Jul 02, 2026 at 10:29:51AM +0200, Krzysztof Kozlowski wrote:
> On 02/07/2026 10:27, Krzysztof Kozlowski wrote:
> > On Wed, Jul 01, 2026 at 05:42:24PM +0200, Ernest Van Hoecke wrote:
> >> From: Ernest Van Hoecke <ernest.vanhoecke at toradex.com>
> >>
> >> qcom,calibration-variant selects board-specific calibration data for
> >> systems where the bus and device IDs are not unique.
> >>
> >> This is not specific to WSI-capable QCN9274 devices. The WSI binding
> >> already allows the property, so allow it in the WCN7850 PCI binding too.
> > 
> > Why? You need to provide reasons WHY do we want this.
> > 

We (Toradex) have SoMs with the SX-PCEBE from Silex, which uses the
WCN7850. Silex provided multiple board files for this to deal with
separate regulatory regions. Thus, we need a mechanism to select which
one to use even though the PCI ID and machines are the same.

> >>
> >> Signed-off-by: Ernest Van Hoecke <ernest.vanhoecke at toradex.com>
> > 
> > Where is any user of this?
> > 
> 
> Actually I missed your link in changelog section. I still however do not
> understand why these are separate. Separate means they are completely
> independent and thus my question about the user stays.
> 
> Best regards,
> Krzysztof

I agree that they could be one patchset and considered replying there,
but felt it easier to discuss this with the relevant patch already
attached. As the other binding already validates this property there is
no real dependency or ordering problem, and I thought this would ease
review.

Kind regards,
Ernest