[PATCH ath-next] wifi: ath12k: Enable monitor mode support on IPQ5332

[Aaradhana Sahu]

Currently, rxdma1_enable and supports_monitor are set to false in
IPQ5332 hardware parameters, which skips monitor ring configuration
and removes NL80211_IFTYPE_MONITOR from the supported interface modes.

Set rxdma1_enable and supports_monitor to true so that monitor rings are
configured and monitor mode is enabled on IPQ5332.

Tested-on: IPQ5332 hw1.0 AHB WLAN.WBE.1.7-00587-QCAHKSWPL_SILICONZ-1

Signed-off-by: Aaradhana Sahu <aaradhana.sahu at oss.qualcomm.com>
---
 drivers/net/wireless/ath/ath12k/wifi7/hw.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/wireless/ath/ath12k/wifi7/hw.c b/drivers/net/wireless/ath/ath12k/wifi7/hw.c
index df045ddf42da..27acdfc35459 100644
--- a/drivers/net/wireless/ath/ath12k/wifi7/hw.c
+++ b/drivers/net/wireless/ath/ath12k/wifi7/hw.c
@@ -617,7 +617,7 @@ static const struct ath12k_hw_params ath12k_wifi7_hw_params[] = {
 			ath12k_wifi7_target_service_to_ce_map_wlan_ipq5332,
 		.svc_to_ce_map_len = 18,
 
-		.rxdma1_enable = false,
+		.rxdma1_enable = true,
 		.num_rxdma_per_pdev = 1,
 		.num_rxdma_dst_ring = 0,
 		.rx_mac_buf_ring = false,
@@ -626,7 +626,7 @@ static const struct ath12k_hw_params ath12k_wifi7_hw_params[] = {
 		.interface_modes = BIT(NL80211_IFTYPE_STATION) |
 				   BIT(NL80211_IFTYPE_AP) |
 				   BIT(NL80211_IFTYPE_MESH_POINT),
-		.supports_monitor = false,
+		.supports_monitor = true,
 
 		.idle_ps = false,
 		.download_calib = true,

base-commit: 20ad0d58517073b3b683ff786c65dd3142321707
-- 
2.34.1