[PATCH ath-current] wifi: ath12k: fix peer_id usage in normal RX path

[Rameshkumar Sundaram]

On 4/27/2026 11:21 AM, Baochen Qiang wrote:
> ath12k_dp_rx_deliver_msdu() currently uses hal_rx_desc_data::peer_id
> parsed from mpdu_start descriptor to do peer lookup. However In an A-MSDU
> aggregation scenario, hardware only populates mpdu_start descriptor for
> the first sub-msdu, but not the following ones. In that case peer_id could
> be invalid, leading to peer lookup failure:
> 
> ath12k_wifi7_pci 0000:06:00.0: rx skb 00000000c391c041 len 1532 peer (null) 0 ucast sn 0 eht320 rate_idx 12 vht_nss 2 freq 6105 band 3 flag 0x40d1a fcs-err 0 mic-err 0 amsdu-more 0
> 
> As a result pubsta is NULL and parts of ieee80211_rx_status structure are
> left uninitialized, which may cause unexpected behavior.
> 
> Fix it by switching the normal RX path to use ath12k_skb_rxcb::peer_id
> which is parsed from REO ring's rx_mpdu_desc and is always valid.
> 
> hal_rx_desc_data::peer_id is still used in
> ath12k_wifi7_dp_rx_frag_h_mpdu(), which is safe since A-MSDU
> aggregation does not occur for fragmented frames. Similarly,
> ath12k_skb_rxcb::peer_id may be overwritten by hal_rx_desc_data::peer_id
> in ath12k_wifi7_dp_rx_h_mpdu(), which only handles non-aggregated
> multicast/broadcast traffic.
> 
> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.1.c5-00302-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.115823.3
> 
> Fixes: 11157e0910fd ("wifi: ath12k: Use ath12k_dp_peer in per packet Tx & Rx paths")
> Signed-off-by: Baochen Qiang <baochen.qiang at oss.qualcomm.com>

Reviewed-by: Rameshkumar Sundaram <rameshkumar.sundaram at oss.qualcomm.com>