[PATCH ath-next V14 8/9] wifi: ath12k: add support for 160 MHz bandwidth

[Nicolas Escande]

On Thu May 22, 2025 at 12:45 AM CEST, Pradeep Kumar Chitrapu wrote:
> Add support to configure maximum NSS in 160 MHz bandwidth.
> Firmware advertises support for handling NSS ratio information
> as a part of service ready ext event using nss_ratio_enabled
> flag. Save this information in ath12k_pdev_cap to calculate
> NSS ratio.
>
> Additionally, reorder the code by moving
> ath12k_peer_assoc_h_phymode() before ath12k_peer_assoc_h_vht()
> to ensure that arg->peer_phymode correctly reflects the bandwidth
> in the max NSS calculation.
>
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
>
> Co-developed-by: P Praneesh <quic_ppranees at quicinc.com>
> Signed-off-by: P Praneesh <quic_ppranees at quicinc.com>
> Signed-off-by: Pradeep Kumar Chitrapu <quic_pradeepc at quicinc.com>
> Acked-by: Jeff Johnson <quic_jjohnson at quicinc.com>
> ---
>  drivers/net/wireless/ath/ath12k/core.h |  2 +
>  drivers/net/wireless/ath/ath12k/mac.c  | 89 ++++++++++++++++++++++----
>  drivers/net/wireless/ath/ath12k/mac.h  |  2 +
>  drivers/net/wireless/ath/ath12k/wmi.c  |  7 +-
>  drivers/net/wireless/ath/ath12k/wmi.h  | 28 ++++++++
>  5 files changed, 115 insertions(+), 13 deletions(-)
[...]
> @@ -2842,10 +2902,13 @@ static enum wmi_phy_mode ath12k_mac_get_phymode_vht(struct ath12k *ar,
>  						    struct ieee80211_link_sta *link_sta)
>  {
>  	if (link_sta->bandwidth == IEEE80211_STA_RX_BW_160) {
> -		if (link_sta->vht_cap.cap & IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160MHZ)
> +		if (link_sta->vht_cap.cap & (IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160MHZ |
> +		    IEEE80211_VHT_CAP_EXT_NSS_BW_MASK))
>  			return MODE_11AC_VHT160;
>  
> -		/* not sure if this is a valid case? */
> +		/* Allow STA to connect even if it does not explicitly advertise 160 MHz
> +		 * support
> +		 */
>  		return MODE_11AC_VHT160;
>  	}
>  
As this will fix the problem encountered before:
Reviewed-by: Nicolas Escande <nico.escande at gmail.com>