[PATCH ath-next v2] wifi: ath12k: allow beacon protection keys to be installed in hardware
Vasanthakumar Thiagarajan
quic_vthiagar at quicinc.com
Mon Jul 7 22:09:21 PDT 2025
On 6/4/2025 3:46 PM, Karthikeyan Kathirvel wrote:
> Install beacon protection keys in hardware for AP modes only if hardware
> supports it, as indicated by the WMI service bit
> WMI_TLV_SERVICE_BEACON_PROTECTION_SUPPORT. Allow keyidx up to 7, since
> beacon protection uses keyidx 6 and 7.
>
> Control this feature by setting bit 0 of feature_enable_bitmap when sending
> the WMI_BCN_TMPL_CMDID command to firmware.
>
> Check for the beacon protection enabled bit in both tx and non-tx profiles
> for MBSSID cases. If set in either profile, enable the beacon protection
> feature in firmware for transmitted vif.
>
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.4.1-00199-QCAHKSWPL_SILICONZ-1
>
> Signed-off-by: Karthikeyan Kathirvel <karthikeyan.kathirvel at oss.qualcomm.com>
Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan at oss.qualcomm.com>
More information about the ath12k
mailing list