[PATCH v9 4/5] wifi: ath12k: Fill pdev id for fw test cmd

[Aaradhana Sahu]

On 1/15/2025 10:56 AM, Aditya Kumar Singh wrote:
> On 1/15/25 09:55, Aaradhana Sahu wrote:
>> Currently pdev id is not set properly. That can cause a crash
>> if pdev id is not equal to the pdev id when firmware test
>> command is run during AP bring up or ping.
>>
>> Set pdev id in function ath12k_tm_cmd_wmi to resolve this
>> issue.
>>
>> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.3.1-00173-QCAHKSWPL_SILICONZ-1
>>
>> Co-developed-by: Rajat Soni <quic_rajson at quicinc.com>
>> Signed-off-by: Rajat Soni <quic_rajson at quicinc.com>
>> Signed-off-by: Aaradhana Sahu <quic_aarasahu at quicinc.com>
>> ---
>>   drivers/net/wireless/ath/ath12k/testmode.c | 11 +++++++++--
>>   1 file changed, 9 insertions(+), 2 deletions(-)
>>
> 
> Previous patch "[PATCH v9 3/5] wifi: ath12k: add factory test mode support" only added testmode.c file isn't it? So can't we squash this patch in that?
> 
> Let's not introduce a bug in patch X and then in same series fix it at patch Y.
> 

This patch does not address any issues related to Factory Test Mode (FTM).
Instead, it focuses only on the ath11k-fwtest command, which is used for
certification testing and is distinct from FTM.

Initially, this patch was submitted independently as '[PATCH v2] wifi: ath12k: Fill pdev id for fw test cmd'
during the internal review.
However, Kalle suggested incorporating this patch with the FTM patches.

As this patch addresses ath11k-fwtest command issue, that's why this is not merge with [PATCH v9 3/5].