[PATCH ath-current] wifi: ath12k: Set EMLSR support flag in MLO flags for EML-capable stations

[Vasanthakumar Thiagarajan]

On 8/1/2025 4:19 PM, Rameshkumar Sundaram wrote:
> From: Ramya Gnanasekar <ramya.gnanasekar at oss.qualcomm.com>
> 
> Currently, when updating EMLSR capabilities of a multi-link (ML) station,
> only the EMLSR parameters (e.g., padding delay, transition delay, and
> timeout) are sent to firmware. However, firmware also requires the
> EMLSR support flag to be set in the MLO flags of the peer assoc WMI
> command to properly handle EML operating mode notification frames.
> 
> Set the ATH12K_WMI_FLAG_MLO_EMLSR_SUPPORT flag in the peer assoc WMI
> command when the ML station is EMLSR-capable, so that the firmware can
> respond to EHT EML action frames from associated stations.
> 
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.4.1-00199-QCAHKSWPL_SILICONZ-1
> 
> Fixes: 4bcf9525bc49 ("wifi: ath12k: update EMLSR capabilities of ML Station")
> Signed-off-by: Ramya Gnanasekar <ramya.gnanasekar at oss.qualcomm.com>
> Signed-off-by: Rameshkumar Sundaram <rameshkumar.sundaram at oss.qualcomm.com>

Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan at oss.qualcomm.com>