[PATCH ath-next 1/3] wifi: ath12k: Add helper function ath12k_mac_update_freq_range()

[Vasanthakumar Thiagarajan]

On 4/8/2025 9:51 AM, Rajat Soni wrote:
> In a subsequent change, the frequency range needs to be updated with
> each regulatory update. Since the current function also modifies the
> DISABLED flag in the actual channel list, which should always align
> with hardware-supported start and end frequencies rather than the
> current operating ones, the existing function cannot be called again.
> Therefore, the logic for setting the frequency range needs to be
> refactored.
> 
> To address this, refactor the frequency setting part into a new
> helper function, ath12k_mac_update_freq_range(). Since this needs
> to be done independently of updating the DISABLED flag, call the new
> helper function ath12k_mac_update_freq_range() after updating the
> channel list for each band.
> 
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.4.1-00199-QCAHKSWPL_SILICONZ-1
> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
> 
> Signed-off-by: Rajat Soni <quic_rajson at quicinc.com>

Reviewed-by: Vasanthakumar Thiagarajan <vasanthakumar.thiagarajan at oss.qualcomm.com>