[PATCH v3 4/4] wifi: ath12k: store and send country code to firmware after recovery

[Jeff Johnson]

On 9/4/2024 7:35 PM, Kang Yang wrote:
> From: Wen Gong <quic_wgong at quicinc.com>
> 
> Currently ath12k does not send the country code to firmware after device
> recovery. As a result the country code will be the default one which
> is reported from firmware. Country code is important, so ath12k also
> need to restore it to the value which was used before recovery.
> 
> This is only needed for platforms which support the current_cc_support
> hardware parameter.
> 
> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
> 
> Signed-off-by: Wen Gong <quic_wgong at quicinc.com>
> Signed-off-by: Kang Yang <quic_kangyang at quicinc.com>
Acked-by: Jeff Johnson <quic_jjohnson at quicinc.com>