ath12k-firmware: WCN7850 hw2.0: add IDs for Acer Swift SFA14-11

[Demon Huang]

  Hello,
  I want to add my laptop's id into the board-2.json:

* description for what hardware this is:

  - Acer Swift SFA14-11, ARM64

* origin of the board file

   - downloaded from
https://git.codelinaro.org/clo/ath-firmware/ath12k-firmware, it was
commited on October 15th.

* ids to be used with the board file

  - WCN7850 hw2.0

    + "bus=pci,vendor=17cb,device=1107,subsystem-vendor=1eac,subsystem-device=8001,qmi-chip-id=2,qmi-board-id=255"
      My device has "subsystem-device=8001", so I'm placing it next to
the existing entry of "subsystem-device=8000".

* attach the actual board file (board.bin)

    + "bus=pci,vendor=17cb,device=1107,subsystem-vendor=105b,subsystem-device=e0dc,qmi-chip-id=2,qmi-board-id=255.bin"
      I'm reusing an existing bin data.

* other message

  After adding the id and repacking it to board-2.bin and then
reloaded the kernel module, I gave a quick test, it can run up to
890Mbps.

  Tested-on: WCN7850 hw2.0 PCI
WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3.

Kind Regards,
Yihao Huang