[PATCH] wifi: ath12k: add display tx and rx bitrate for 11be

[Jeff Johnson]

On 1/4/2024 8:50 AM, Jeff Johnson wrote:
> On 1/3/2024 7:22 PM, Lingbo Kong wrote:
>> When AP is in 11be state, STA's tx/rx bitrate display error value using iw
>> dev wlan command.
>>
>> In ath12k_dp_tx_update_txcompl() function, not handle the case when
>> pkt_type is equal to HAL_TX_RATE_STATS_PKT_TYPE_11BE, so add a else if
>> statement to handle this situation.
>>
>> In ath12k_dp_rx_h_rate function, not handle the case when pkt_type is equal
>> to RX_MSDU_START_PKT_TYPE_11BE, so add a case statement to handle this
>> situation.
>>
>> After that, "iw dev xxx station dump" show the correct tx bitrate such as:
>> tx bitrate: 1441.1 MBit/s 80MHz EHT-MCS 13 EHT-NSS 2 EHT-GI 0
>> rx bitrate: 1441.1 MBit/s 80MHz EHT-MCS 9 EHT-NSS 3 EHT-GI 0
>>
>> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4
>>
>> Signed-off-by: Lingbo Kong <quic_lingbok at quicinc.com>
> Acked-by: Jeff Johnson <quic_jjohnson at quicinc.com>
> 

Tested-by: Owen Mesh <owen.mesh at gmail.com>