[PATCH 2/2] wifi: ath12k: Add QMI PHY capability learn support

[Kalle Valo]

Karthikeyan Periyasamy <quic_periyasa at quicinc.com> wrote:

> Currently, the number of PHY is learned from the firmware service ready
> event message. However, on the QCN9274 platform, number of PHY is a
> variable parameter. To enable MLO capability in the QMI host capability
> request message, the driver needs the PHY count information earlier than
> the firmware service ready event. Therefore, a new QMI message,
> "PHY capability message", is introduced to retrieve this information.
> This message allows the driver to fill in the MLO parameter in the QMI
> host capability request message. If the new QMI PHY capability message
> fails, the default configuration in the HW params will be used.
> 
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
> 
> Signed-off-by: Karthikeyan Periyasamy <quic_periyasa at quicinc.com>
> Acked-by: Jeff Johnson <quic_jjohnson at quicinc.com>
> Signed-off-by: Kalle Valo <quic_kvalo at quicinc.com>

I did some cosmetic changes to this patch: s/{ }/{}/, lower case debug messages etc.

-- 
https://patchwork.kernel.org/project/linux-wireless/patch/20240113001659.1022465-3-quic_periyasa@quicinc.com/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches