[PATCH v2] wifi: ath12k: Set default beacon mode to burst mode

[Sidhanta Sahu]

Currently, firmware does not like when beacon mode is set as staggered
mode for more than one beaconing vifs. Beacon mode for multiple
beaconing (transmitted) vifs are expected to be in burst mode. So set
beacon mode to burst mode by default.

Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1

Signed-off-by: Sidhanta Sahu <quic_sidhanta at quicinc.com>
---
v2: Modified the debug log.

 drivers/net/wireless/ath/ath12k/mac.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/wireless/ath/ath12k/mac.c b/drivers/net/wireless/ath/ath12k/mac.c
index 1bb9802ef569..d38b85eaed37 100644
--- a/drivers/net/wireless/ath/ath12k/mac.c
+++ b/drivers/net/wireless/ath/ath12k/mac.c
@@ -2314,7 +2314,7 @@ static void ath12k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
 
 	if (changed & BSS_CHANGED_BEACON) {
 		param_id = WMI_PDEV_PARAM_BEACON_TX_MODE;
-		param_value = WMI_BEACON_STAGGERED_MODE;
+		param_value = WMI_BEACON_BURST_MODE;
 		ret = ath12k_wmi_pdev_set_param(ar, param_id,
 						param_value, ar->pdev->pdev_id);
 		if (ret)
@@ -2322,7 +2322,7 @@ static void ath12k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
 				    arvif->vdev_id);
 		else
 			ath12k_dbg(ar->ab, ATH12K_DBG_MAC,
-				   "Set staggered beacon mode for VDEV: %d\n",
+				   "Set burst beacon mode for VDEV: %d\n",
 				   arvif->vdev_id);
 
 		ret = ath12k_mac_setup_bcn_tmpl(arvif);
-- 
2.17.1