[PATCH v4 03/11] wifi: ath12k: WMI support to process EHT capabilities

Wen Gong quic_wgong at quicinc.com
Fri Jun 16 03:50:52 PDT 2023


On 6/15/2023 7:49 PM, Kalle Valo wrote:
> Aloka Dixit <quic_alokad at quicinc.com> writes:
>
>> Add WMI support to process the EHT capabilities passed by
>> the firmware. Add required EHT specific definitions in
>> structures ath12k_band_cap and ath12k_wmi_svc_rdy_ext_parse.
>>
>> For single_pdev chip such as WCN7850, only one pdev is created
>> and only one hardware is registered to mac80211. This one pdev
>> manages both 2.4 GHz radio and 5 GHz/6 GHz radio.
>>
>> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
>> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0-03427-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.15378.4
>> Signed-off-by: Aloka Dixit <quic_alokad at quicinc.com>
>> Co-developed-by: Pradeep Kumar Chitrapu <quic_pradeepc at quicinc.com>
>> Signed-off-by: Pradeep Kumar Chitrapu <quic_pradeepc at quicinc.com>
>> Co-developed-by: Wen Gong <quic_wgong at quicinc.com>
>> Signed-off-by: Wen Gong <quic_wgong at quicinc.com>
> [...]
>
>> +struct ath12k_fw_pdev {
>> +	u32 pdev_id;
>> +	u32 phy_id;
>> +	u32 supported_bands;
>> +};
> So we have now two very similar structures, ath12k_pdev and
> ath12k_fw_pdev. It would be good to document above the structs their
> purpose. Any ideas what I could add?

For single_pdev, the ath12k_pdev is always one pdev.

and ath12k_fw_pdev is more than one for single_pdev.

>



More information about the ath12k mailing list