[PATCH] wifi: ath12k: Set default beacon mode to burst mode

[Jeff Johnson]

On 8/30/2023 12:46 PM, Sidhanta Sahu wrote:
> Currently, firmware does not like when beacon mode is set as staggered
> mode for more than one beaconing vifs. Beacon mode for multiple
> beaconing (transmitted) vifs are expected to be in burst mode. So set
> beacon mode to burst mode by default.
> 
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
> 
> Signed-off-by: Sidhanta Sahu <quic_sidhanta at quicinc.com>

Acked-by: Jeff Johnson <quic_jjohnson at quicinc.com>

> ---
>   drivers/net/wireless/ath/ath12k/mac.c | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/net/wireless/ath/ath12k/mac.c b/drivers/net/wireless/ath/ath12k/mac.c
> index 1bb9802ef569..b16cbc3c906d 100644
> --- a/drivers/net/wireless/ath/ath12k/mac.c
> +++ b/drivers/net/wireless/ath/ath12k/mac.c
> @@ -2314,7 +2314,7 @@ static void ath12k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
>   
>   	if (changed & BSS_CHANGED_BEACON) {
>   		param_id = WMI_PDEV_PARAM_BEACON_TX_MODE;
> -		param_value = WMI_BEACON_STAGGERED_MODE;
> +		param_value = WMI_BEACON_BURST_MODE;
>   		ret = ath12k_wmi_pdev_set_param(ar, param_id,
>   						param_value, ar->pdev->pdev_id);
>   		if (ret)