[PATCH ath-next 0/3] wifi: ath11k: monitor frames: length, FCS failures and rates

Christopher Griffin via B4 Relay devnull+christophergriffin05.gmail.com at kernel.org
Sun Nov 1 21:14:08 PST 2026


Three fixes to what an ath11k monitor interface hands to mac80211, found
capturing with the QCN9072 scan radio of an Arista C-360:

1. Size monitor MPDUs by the chip's rx descriptor. On a QCN9074 a
   monitor frame kept its FCS plus 4 stale bytes, unflagged.
2. Hold back FCS-failed monitor frames unless a monitor asked for them
   (FIF_FCSFAIL), as ath10k does.
3. Report a monitor frame's MCS and NSS only when the PPDU's SIG was
   seen, so mac80211 no longer warns about, and drops, a VHT/HE rate
   with no NSS.

The series applies on top of these four, all still under review:
- [PATCH ath-next 0/2] wifi: ath11k: two monitor destination ring fixes
  <20261024-ath11k-monitor-buffers-v1-0-ff155feca2f6 at gmail.com>
- [PATCH ath-next] wifi: ath11k: update rx_channel on a channel switch
  <20261024-ath11k-rx-channel-switch-v1-1-5fc2ba53ca8f at gmail.com>
- [PATCH ath-next] wifi: ath11k: report the measured noise floor of the
  channel in use
  <20261024-ath11k-survey-noise-floor-v1-1-8eb03002aab8 at gmail.com>
- [PATCH ath-next] wifi: ath11k: add the measured noise floor, not -95,
  to a received signal
  <20261029-ath11k-signal-noise-floor-v1-1-8867d25298c8 at gmail.com>

Tested on an Arista C-360 (IPQ8074 + QCN9074/QCN9072) with OpenWrt
main, these as backports, on the QCN9072 scan radio's monitor (no
fcsfail flag), comparing captures of the same air:
- frames ending in an unflagged FCS: 353 of 400 (88%) before, 0 of 800
  with the series; beacons whose elements end at the frame's end: 1 of
  43 before, 60 of 60 with it;
- frames with a bad FCS: 44 of 400 (11%) before, 0 of 800 with it;
- no "Rate marked as a VHT rate but data is invalid" warning during
  the run (it showed once before, in a longer capture).

---
Christopher Griffin (3):
      wifi: ath11k: size monitor MPDUs by the chip's rx descriptor
      wifi: ath11k: hold back FCS-failed monitor frames unless asked for
      wifi: ath11k: report a monitor frame's MCS and NSS only from the PPDU's SIG

 drivers/net/wireless/ath/ath11k/dp_rx.c | 75 +++++++++++++++++++++++++++------
 drivers/net/wireless/ath/ath11k/mac.c   |  3 +-
 2 files changed, 63 insertions(+), 15 deletions(-)
---
base-commit: c5546d76a980fc035b20fb7932e191e6138dcb91
change-id: 20261101-b8-monitor-frames-b4e98941e50d

Best regards,
--  
Christopher Griffin <christophergriffin05 at gmail.com>





More information about the ath11k mailing list