[RFC] [PATCH v2 10/13] wifi: ath11k: bind to QRTR endpoint ID in ath11k_qmi_init_service

[Mihai Moldovan]

If possible, fetch the QRTR endpoint ID in ath11k_qmi_init_service, just
before calling qmi_handle_init, and make it available in the qmi_handle.

qmi_helpers will then automatically bind to this endpoint for us.

This finally allows using multiple ath11k-based cards with the same QRTR
node/port combination to work simultanenous (and, for that matter, at
all).

Signed-off-by: Mihai Moldovan <ionic at ionic.de>
Tested-on: QCA6390 hw2.0 PCI WLAN.HST.1.0.1-05266-QCAHSTSWPLZ_V2_TO_X86-1
---
 drivers/net/wireless/ath/ath11k/qmi.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/net/wireless/ath/ath11k/qmi.c b/drivers/net/wireless/ath/ath11k/qmi.c
index 5759fc521316..604d7211b980 100644
--- a/drivers/net/wireless/ath/ath11k/qmi.c
+++ b/drivers/net/wireless/ath/ath11k/qmi.c
@@ -15,6 +15,7 @@
 #include <linux/ioport.h>
 #include <linux/firmware.h>
 #include <linux/of_irq.h>
+#include <net/sock.h>
 
 #define SLEEP_CLOCK_SELECT_INTERNAL_BIT	0x02
 #define HOST_CSTATE_BIT			0x04
@@ -3315,6 +3316,13 @@ int ath11k_qmi_init_service(struct ath11k_base *ab)
 	ab->qmi.ab = ab;
 
 	ab->qmi.target_mem_mode = ab->hw_params.fw_mem_mode;
+
+	ret = ath11k_set_qrtr_endpoint_id(ab);
+	if (ret) {
+		ath11k_warn(ab, "failed to set QRTR endpoint ID: %d\n", ret);
+		ath11k_warn(ab, "only one device per system will be supported\n");
+	}
+
 	ret = qmi_handle_init(&ab->qmi.handle, ATH11K_QMI_RESP_LEN_MAX,
 			      &ath11k_qmi_ops, ath11k_qmi_msg_handlers);
 	if (ret < 0) {
-- 
2.45.2