wcn6855 2.1 - slow download speed on any pairwise cipher except CCMP

[Yaroslav Isakov]

Hello!

вт, 2 апр. 2024 г. в 02:35, Baochen Qiang <quic_bqiang at quicinc.com>:
>
>
>
> On 4/1/2024 10:53 PM, Jeff Johnson wrote:
> > On 3/31/2024 8:49 AM, Yaroslav Isakov wrote:
> >> Hello! When I tried to switch my OpenWRT router from default CCMP
> >> pairwise cipher to any other, supported by both my router (Asus
> >> TUF-AX6000) and my laptop (Thinkpat T14 Gen 4 AMD with WCN6855 2.1), I
> >> saw that download dropped from 1Gbit/s to 100 MBit/s. When I changed
> >> back to CCMP, download speed recovered back to 1Gbit/s. Upload speed
> >> is good, though, for all ciphers - 1Gbit/s.
> >>
> >> Initially, I thought, that issue with either router hardware, or
> >> openwrt driver - but, I tested the same settings on another laptop -
> >> T14 Gen3 Intel - and with Intel WIFI, both download and upload speed
> >> was 1Gbit/s on any pairwise cipher.
> >>
> >> This issue is 100% reproducible for me, it happens all the times I'm
> >> switching to any pairwise cipher other than CCMP.
> >>
> >> I'm on Linux 6.7.6, compiled from sources on Gentoo.
> I'm not familiar with Gentoo, is there any private changes in it
> compared to upstream ath11k? If there indeed is, could you try Kalle's
> ath11k tree?
>
> https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/
>
Sorry, missed the message. Gentoo kernel I'm using is very close to
upstream. I will try ath11.git, and will report there, thank you.

> >>
> >> Here is my dmesg for ath11k:
> >> [   13.092519] ath11k_pci 0000:02:00.0: BAR 0: assigned [mem
> >> 0x78600000-0x787fffff 64bit]
> >> [   13.093400] ath11k_pci 0000:02:00.0: enabling device (0000 -> 0002)
> >> [   13.095723] ath11k_pci 0000:02:00.0: MSI vectors: 32
> >> [   13.096260] ath11k_pci 0000:02:00.0: wcn6855 hw2.1
> >> [   13.974707] ath11k_pci 0000:02:00.0: chip_id 0x12 chip_family 0xb
> >> board_id 0xff soc_id 0x400c1211
> >> [   13.974732] ath11k_pci 0000:02:00.0: fw_version 0x1106196e
> >> fw_build_timestamp 2024-01-12 11:30 fw_build_id
> >> WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3.6510.37
> >> [   14.315774] ath11k_pci 0000:02:00.0: Failed to set the requested
> >> Country regulatory setting
> >> [   14.316046] ath11k_pci 0000:02:00.0: Failed to set the requested
> >> Country regulatory setting
> >> [  337.889222] ath11k_pci 0000:02:00.0: failed to enqueue rx buf: -28
> >>
> >
> > There was another reporting of that error in this thread:
> > https://lore.kernel.org/all/5c63a3a2-29fe-444c-96f1-f87c89d7af39@gmail.com/
> >
> I don't think this is the same issue as reported by James there although
> same error message. For now I don't know the root cause to that message
> but it's unlikely it causes some tput issue.
>
> Let's wait for Yasoslav verifying it on latest ath.git.
>
> > +Baochen Qiang for awareness
> >
> > /jeff