[PATCH 0/2] ath11k: factory test mode support

[Kalle Valo]

Raj Kumar Bhagat <quic_rajkbhag at quicinc.com> writes:

> On 3/13/2023 5:51 PM, Kalle Valo wrote:
>
>> Raj Kumar Bhagat <quic_rajkbhag at quicinc.com> writes:
>> 
>>> Device is booted in factory test mode to calibrate the board.
>>> The commands are sent from a userspace application, which is
>>> sent to firmware using wmi commands. Firmware will send the
>>> response back to the application which stores the calibration
>>> data in caldata.bin file. This file will be loaded when the
>>> device boots up normally next time.
>>>
>>> Govindaraj Saminathan (1):
>>>   wifi: ath11k: factory test mode support
>>>
>>> Sowmiya Sree Elavalagan (1):
>>>   wifi: ath11k: Allow ath11k to boot without caldata in ftm mode
>> 
>> While reviewing the patches I made quite a few style cleanup to patches
>> (too many to list):
>> 
>> https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=4a5ca29c396ace5c46b208a8c15a3ba53eabaddd
>> 
>> https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=ba74c7478f5d15ce38e609b9ad4810db7511a3dd
>> 
>> I only compile tested them. Please use these as the baseline for v2.
>> 
> Hi Kalle,
>
> Unable to get the baseline patch for v2 from the above link. Getting the
> below error with the link:
> Bad commit reference: 4a5ca29c396ace5c46b208a8c15a3ba53eabaddd

I now pushed them again:

https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=pending&id=f3d1f7ae115e12108ba7d7fa0ea6374b9e28869c

https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=pending&id=229ea354bdd24bf3c33c9447674fab8d609e24a2

>From now I'll tag every time I change the pending branch, this should
prevent old commits from disappearing.

-- 
https://patchwork.kernel.org/project/linux-wireless/list/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches