[PATCH 3/3] wifi: ath11k: fix Tx power value during active CAC

[Aditya Kumar Singh]

Tx power is fetched from firmware's pdev stats. However, during active
CAC, firmware does not fill the current Tx power and sends the max
initialised value filled during firmware init. If host sends this power
to user space, this is wrong since in certain situations, the Tx power
could be greater than the max allowed by the regulatory. Hence, host
should not be fetching the Tx power during an active CAC.

Fix this issue by returning Tx power as 0 during active CAC since it
is known that during CAC, there will be no transmission happening.

Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1

Fixes: 9a2aa68afe3d ("wifi: ath11k: add get_txpower mac ops")
Signed-off-by: Aditya Kumar Singh <quic_adisi at quicinc.com>
---
 drivers/net/wireless/ath/ath11k/mac.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c
index 31982545266b..9707910928b4 100644
--- a/drivers/net/wireless/ath/ath11k/mac.c
+++ b/drivers/net/wireless/ath/ath11k/mac.c
@@ -9045,6 +9045,14 @@ static int ath11k_mac_op_get_txpower(struct ieee80211_hw *hw,
 	if (ar->state != ATH11K_STATE_ON)
 		goto err_fallback;
 
+	/* Firmware doesn't provide Tx power during CAC hence no need to fetch
+	 * the stats.
+	 */
+	if (test_bit(ATH11K_CAC_RUNNING, &ar->dev_flags)) {
+		mutex_unlock(&ar->conf_mutex);
+		return -EAGAIN;
+	}
+
 	req_param.pdev_id = ar->pdev->pdev_id;
 	req_param.stats_id = WMI_REQUEST_PDEV_STAT;
 
-- 
2.17.1