[PATCH] wifi: ath11k: update proper pdev/vdev id for testmode command

[Raj Kumar Bhagat]

On 4/26/2023 12:59 PM, Kalle Valo wrote:
> Raj Kumar Bhagat <quic_rajkbhag at quicinc.com> writes:
> 
>> From: Venkateswara Naralasetty <quic_vnaralas at quicinc.com>
>>
>> User can extend test mode command support to set vdev and pdev params
>> for debug purpose at run time by sending vdev/pdev param set command
>> through the testmode command interface.
>>
>> Fill the proper pdev/vdev id in driver since, pdev/vdev id details may
>> not be available at user space. It will make sure that the proper
>> vdev/pdev ids are sent to firmware.
>>
>> Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1
>>
>> Depends-On:
>> 	[v3,3/4] wifi: ath11k: factory test mode support
>>
>> Signed-off-by: Venkateswara Naralasetty <quic_vnaralas at quicinc.com>
>> Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag at quicinc.com>
>> ---
> 
> Please add 'Depends-on' after the '---' line. This is for future
> patches, no need to resend because of this.
> 

Thanks for pointing this. Will take care for future patches.

Thanks,
Raj