[PATCH v3 15/15] wifi: ath11k: send TPC power to firmware for 6 GHz station

[Wen Gong]

When station is connected to a 6 GHz AP, it has 2 way to configure
the power limit to firmware. The first way is to send 2 wmi command
WMI_PDEV_PARAM_TXPOWER_LIMIT2G/WMI_PDEV_PARAM_TXPOWER_LIMIT5G to
firmware, the second way is to send WMI_VDEV_SET_TPC_POWER_CMDID to
firmware which include more parameters for power control.

The first way is disabled in previous patch
"ath11k: discard BSS_CHANGED_TXPOWER when EXT_TPC_REG_SUPPORT for 6 GHz".

Prepare the parameter for wmi command WMI_VDEV_SET_TPC_POWER_CMDID and
send the firmware after vdev start response success from firmware, it
is for the second way of power control.

Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1

Signed-off-by: Wen Gong <quic_wgong at quicinc.com>
---
 drivers/net/wireless/ath/ath11k/mac.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c
index 54d7327265d6..1d9eebfe84fa 100644
--- a/drivers/net/wireless/ath/ath11k/mac.c
+++ b/drivers/net/wireless/ath/ath11k/mac.c
@@ -6724,6 +6724,12 @@ ath11k_mac_vdev_start_restart(struct ath11k_vif *arvif,
 		return ret;
 	}
 
+	if (ath11k_mac_supports_station_tpc(ar, arvif, chandef)) {
+		ath11k_mac_fill_reg_tpc_info(ar, arvif->vif, &arvif->chanctx);
+		ath11k_wmi_send_vdev_set_tpc_power(ar, arvif->vdev_id,
+						   &arvif->reg_tpc_info);
+	}
+
 	if (!restart)
 		ar->num_started_vdevs++;
 
@@ -7494,7 +7500,7 @@ ath11k_mac_op_assign_vif_chanctx(struct ieee80211_hw *hw,
 		if (power_type == IEEE80211_REG_UNSET_AP)
 			power_type = IEEE80211_REG_LPI_AP;
 		ath11k_reg_handle_chan_list(ab, reg_info, power_type);
-
+		arvif->chanctx = *ctx;
 		ath11k_mac_parse_tx_pwr_env(ar, vif, ctx);
 	}
 
-- 
2.31.1