[PATCH v2 1/2] wifi: ath11k: change to set 11d state instead of start 11d scan while disconnect

[Wen Gong]

On 10/11/2022 11:53 AM, Wen Gong wrote:
> On 10/11/2022 2:09 AM, Kalle Valo wrote:
>> Wen Gong <quic_wgong at quicinc.com> wrote:
>>
>>> When switch to connect to a new AP for station which is already 
>>> connected
>>> to an AP, the time cost is too long, it arrives 10 seconds.
>>>
>>> The reason is when switch connection, disconnect operation happened on
>>> the 1st AP, then 11d scan start command sent to firmware, and then a
>>> new hw scan arrived for the 2nd AP. The 11d scan is running at this
>>> moment, so the hw scan can not start immediately, it needs to wait
>>> the 11d scan finished, it increased the time cost of switch AP and
>>> even happened scan fail as log below after apply the incoming patch.
>>>
>>> [ 1194.815104] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
>>> [ 1196.864157] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
>>> [ 1198.911926] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
>>>
>>> Change to set 11d state while disconnect, and the 11d scan will be
>>> started after the new hw scan in ath11k_mac_op_hw_scan(). Then the
>>> time cost of switching AP is small and not happened scan fail.
>>>
>>> Tested-on: WCN6855 hw2.0 PCI 
>>> WLAN.HSP.1.1-03125-QCAHSPSWPL_V1_V2_SILICONZ_LITE-3
>>>
>>> Fixes: 9dcf6808b253 ("ath11k: add 11d scan offload support")
>>> Signed-off-by: Wen Gong <quic_wgong at quicinc.com>
>>> Signed-off-by: Kalle Valo <quic_kvalo at quicinc.com>
>> I still see warnings:
>>
>> [ 3627.691737] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
>> [ 3715.435608] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
>> [ 3860.333214] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
>> [ 4542.000955] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
>> [ 4604.018451] ath11k_pci 0000:06:00.0: failed to start hw scan: -110
> The failed log is now happened frequently as before, I will change it 
> again to suppress the failed log.
change typo.
The failed log is NOT happened frequently as before, I will change it 
again to suppress the failed log.
>> 2 patches set to Changes Requested.
>>
>> 12991768 [v2,1/2] wifi: ath11k: change to set 11d state instead of 
>> start 11d scan while disconnect
>> 12991769 [v2,2/2] wifi: ath11k: reduce the timeout value back for hw 
>> scan from 10 seconds to 1 second
>>