[PATCH 2/2] wifi: ath11k: use unique QRTR instance ID

[Kalle Valo]

Manivannan Sadhasivam <mani at kernel.org> writes:

> On Sat, Nov 05, 2022 at 08:49:43PM +0100, Robert Marko wrote:
>> Currently, trying to use AHB + PCI/MHI cards or multiple PCI/MHI cards
>> will cause a clash in the QRTR instance node ID and prevent the driver
>> from talking via QMI to the card and thus initializing it with:
>> [    9.836329] ath11k c000000.wifi: host capability request failed: 1 90
>> [    9.842047] ath11k c000000.wifi: failed to send qmi host cap: -22
>> 
>
> There is still an outstanding issue where you cannot connect two WLAN modules
> with same node id.
>
>> So, in order to allow for this combination of cards, especially AHB + PCI
>> cards like IPQ8074 + QCN9074 (Used by me and tested on) set the desired
>> QRTR instance ID offset by calculating a unique one based on PCI domain
>> and bus ID-s and writing it to bits 7-0 of BHI_ERRDBG2 MHI register by
>> using the SBL state callback that is added as part of the series.
>> We also have to make sure that new QRTR offset is added on top of the
>> default QRTR instance ID-s that are currently used in the driver.
>> 
>
> Register BHI_ERRDBG2 is listed as Read only from Host as per the BHI spec.
> So I'm not sure if this solution is going to work on all ath11k supported
> chipsets.
>
> Kalle, can you confirm?

I can't look at this in detail right now, but hopefully in few days.
I'll get back to you.

-- 
https://patchwork.kernel.org/project/linux-wireless/list/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches