[PATCH] ath11k: Clear auth flag only for actual association in security mode

[Kalle Valo]

Rameshkumar Sundaram <quic_ramess at quicinc.com> wrote:

> AUTH flag is needed when peer assoc command is sent from host in
> security mode for non-assoc cases. Firmware will handle AUTH flag
> when client is associating as AUTH flag will be set after key exchange.
> For internally provided peer assoc commands from host, there won't be
> any key exchange, so AUTH flag is expected to be set in host.
> 
> Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.4.0.1-01838-QCAHKSWPL_SILICONZ-1
> 
> Co-developed-by: Lavanya Suresh <lavaks at codeaurora.org>
> Signed-off-by: Lavanya Suresh <lavaks at codeaurora.org>
> Signed-off-by: Rameshkumar Sundaram <quic_ramess at quicinc.com>
> Signed-off-by: Kalle Valo <kvalo at codeaurora.org>

Patch applied to ath-next branch of ath.git, thanks.

c802b6d7815d ath11k: Clear auth flag only for actual association in security mode

-- 
https://patchwork.kernel.org/project/linux-wireless/patch/1635177786-20854-1-git-send-email-quic_ramess@quicinc.com/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches