[PATCH v2 1/3] nl80211: Add support for beacon tx mode

[jjohnson at codeaurora.org]

On 2021-04-29 04:47, Maharaja Kennadyrajan wrote:
[..snip..]
> +/**
> + * enum nl80211_beacon_tx_mode - Beacon Tx Mode enum.
> + *      Used to configure beacon staggered mode or beacon burst mode.
> + */
> +enum nl80211_beacon_tx_mode {
> +	NL80211_BEACON_STAGGERED_MODE = 1,
> +	NL80211_BEACON_BURST_MODE = 2,
> +};
> +
[..snip..]
> @@ -5330,6 +5331,10 @@ static int nl80211_start_ap(struct sk_buff *skb,
> struct genl_info *info)
>  	params.dtim_period =
>  		nla_get_u32(info->attrs[NL80211_ATTR_DTIM_PERIOD]);
> 
> +	if (info->attrs[NL80211_ATTR_BEACON_TX_MODE])
> +		params.beacon_tx_mode =
> +
> nla_get_u32(info->attrs[NL80211_ATTR_BEACON_TX_MODE]);
> +

Note that in the case where NL80211_ATTR_BEACON_TX_MODE is not specified 
that
beacon_tx_mode will be zero, which is not a valid nl80211_beacon_tx_mode 
enumeration.

Should you renumber the nl80211_beacon_tx_mode enumerations so that the 
default
mode has a value of 0? Or add NL80211_BEACON_DEFAULT_MODE = 0 and allow 
the driver
to select a default mode?