Ordering Dell XPS 13 9310 to test QCA6390
Justin Mazzola Paluska
jmp at justinmp.com
Sat Jan 16 09:10:58 EST 2021
On 1/13/21 1:29 PM, Luo, Sining wrote:
> Yes, it was enabled in BIOS, but it wasn't enabled at boot due to the
> BIOS bug:
> DMAR: [Firmware Bug]: Your BIOS is broken; DMAR reported at address 0!
>
> I went ahead to upgrade the BIOS to 1.2.5. The DMAR error is now gone
> and I can get 32 MSI vectors for the first time!
>
> [ 3.971218] ath11k_pci 0000:72:00.0: WARNING: ath11k PCI support is
> experimental!
> [ 3.971285] ath11k_pci 0000:72:00.0: BAR 0: assigned [mem 0xa2500000-
> 0xa25fffff 64bit]
> [ 3.971302] ath11k_pci 0000:72:00.0: enabling device (0000 -> 0002)
> [ 3.971452] ath11k_pci 0000:72:00.0: MSI vectors: 32
> [ 4.609593] ath11k_pci 0000:72:00.0: qmi req mem_seg[0] 0x53c00000
> 3522560 1
> [ 4.609595] ath11k_pci 0000:72:00.0: qmi req mem_seg[1] 0x54100000
> 884736 4
> [ 4.616396] ath11k_pci 0000:72:00.0: chip_id 0x0 chip_family 0xb
> board_id 0xff soc_id 0xffffffff
> [ 4.616398] ath11k_pci 0000:72:00.0: fw_version 0x101c06cc
> fw_build_timestamp 2020-06-24 19:50 fw_build_id
> [ 4.793650] ath11k_pci 0000:72:00.0 wlp114s0: renamed from wlan0
>
For what it's worth, I upgraded my Dell XPS 13 9310 to BIOS 1.2.5 and
can also report that the DMAR error is gone and I also get 32 MSI vectors.
$ sudo dmesg | grep -e ath11k\\\|mhi
[ 17.317099] ath11k_pci 0000:56:00.0: WARNING: ath11k PCI support is
experimental!
[ 17.317153] ath11k_pci 0000:56:00.0: BAR 0: assigned [mem
0x8c300000-0x8c3fffff 64bit]
[ 17.317170] ath11k_pci 0000:56:00.0: enabling device (0000 -> 0002)
[ 17.317336] ath11k_pci 0000:56:00.0: MSI vectors: 32
[ 17.375022] mhi 0000:56:00.0: Requested to power ON
[ 17.375181] mhi 0000:56:00.0: Power on setup success
[ 17.945671] ath11k_pci 0000:56:00.0: qmi req mem_seg[0] 0x33000000
3522560 1
[ 17.945675] ath11k_pci 0000:56:00.0: qmi req mem_seg[1] 0x33500000
884736 4
[ 17.953054] ath11k_pci 0000:56:00.0: chip_id 0x0 chip_family 0xb
board_id 0xff soc_id 0xffffffff
[ 17.953056] ath11k_pci 0000:56:00.0: fw_version 0x101c06cc
fw_build_timestamp 2020-06-24 19:50 fw_build_id
[ 18.127165] ath11k_pci 0000:56:00.0 wlp86s0: renamed from wlan0
I'm still using the ath11k-qca6390-bringup-202012140938 branch. I'm
happy to try out new patches, particularly ones related to power
management. The laptop doesn't get into states lower than pc6 while the
wireless card is running. If I shut down the card, the laptop will
opportunistically get down into the pc10 state, which leads to massive
power savings.
--Justin
More information about the ath11k
mailing list