[PATCH 11/11] ath11k: add qcn9074 pci device support

[Anilkumar Kolli]

QCN9074 is PCI based 11ax radio.
	- has 2G/5G/6G variants.
	- has NSS 2x2 and 4x4 variants.

QCN9074 uses 45MB of HOST DDR memory, target requests host memory in
segments, each segment is of 2MB size and is physcial contiguous and
use static window configuration.

Below QMI issues are seen with QCN9074,
Issue 1:
 ath11k_pci 0000:06:00.0: qmi failed memory request, err = -110
 ath11k_pci 0000:06:00.0: qmi failed to respond fw mem req:-110
Issue 2:
 ath11k_pci 0000:06:00.0: firmware crashed: MHI_CB_SYS_ERROR
 ath11k_pci 0000:06:00.0: qmi failed set mode request, mode: 0, err = -110
 ath11k_pci 0000:06:00.0: qmi failed to send wlan fw mode:-110

Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.4.0.1.r2-00012-QCAHKSWPL_SILICONZ-1

Signed-off-by: Anilkumar Kolli <akolli at codeaurora.org>
---
 drivers/net/wireless/ath/ath11k/pci.c | 20 ++++++++++++++++++--
 1 file changed, 18 insertions(+), 2 deletions(-)

diff --git a/drivers/net/wireless/ath/ath11k/pci.c b/drivers/net/wireless/ath/ath11k/pci.c
index 70dcb80475b1..259a39e59a91 100644
--- a/drivers/net/wireless/ath/ath11k/pci.c
+++ b/drivers/net/wireless/ath/ath11k/pci.c
@@ -34,10 +34,12 @@
  */
 #define ACCESS_ALWAYS_OFF 0xFE0
 
-#define QCA6390_DEVICE_ID		0x1101
+#define QCA6390_DEVICE_ID              0x1101
+#define QCN9074_DEVICE_ID              0x1104
 
 static const struct pci_device_id ath11k_pci_id_table[] = {
 	{ PCI_VDEVICE(QCOM, QCA6390_DEVICE_ID) },
+	{ PCI_VDEVICE(QCOM, QCN9074_DEVICE_ID) },
 	{0}
 };
 
@@ -61,6 +63,15 @@ static const struct ath11k_msi_config ath11k_msi_config[] = {
 			{ .name = "DP", .num_vectors = 18, .base_vector = 14 },
 		},
 	},
+	{
+		.total_vectors = 16,
+		.total_users = 3,
+		.users = (struct ath11k_msi_user[]) {
+			{ .name = "MHI", .num_vectors = 3, .base_vector = 0 },
+			{ .name = "CE", .num_vectors = 5, .base_vector = 3 },
+			{ .name = "DP", .num_vectors = 8, .base_vector = 8 },
+		},
+	},
 };
 
 static const char *irq_name[ATH11K_IRQ_NUM_MAX] = {
@@ -1219,6 +1230,12 @@ static int ath11k_pci_probe(struct pci_dev *pdev,
 			ret = -EOPNOTSUPP;
 			goto err_pci_free_region;
 		}
+		ab_pci->msi_config = &ath11k_msi_config[0];
+		break;
+	case QCN9074_DEVICE_ID:
+		ab_pci->msi_config = &ath11k_msi_config[1];
+		ab->bus_params.static_window_map = true;
+		ab->hw_rev = ATH11K_HW_QCN9074_HW10;
 		break;
 	default:
 		dev_err(&pdev->dev, "Unknown PCI device found: 0x%x\n",
@@ -1227,7 +1244,6 @@ static int ath11k_pci_probe(struct pci_dev *pdev,
 		goto err_pci_free_region;
 	}
 
-	ab_pci->msi_config = &ath11k_msi_config[0];
 	ret = ath11k_pci_enable_msi(ab_pci);
 	if (ret) {
 		ath11k_err(ab, "failed to enable msi: %d\n", ret);
-- 
2.7.4