[PATCHv2] ath11k: add raw mode and software crypto support

[vnaralas at codeaurora.org]

On 2020-09-17 20:48, Kalle Valo wrote:
> Venkateswara Naralasetty <vnaralas at codeaurora.org> writes:
> 
>> Adding raw mode tx/rx support. Also, adding support
>> for software crypto which depends on raw mode.
>> 
>> To enable raw mode tx/rx:
>> insmod ath11k.ko frame_mode=0
>> 
>> To enable software crypto:
>> insmod ath11k.ko crypto_mode=1
>> 
>> These modes could be helpful in debugging crypto related issues.
>> 
>> Tested-on: IPQ8074 WLAN.HK.2.1.0.1-01228-QCAHKSWPL_SILICONZ-1
>> 
>> Signed-off-by: Manikanta Pubbisetty <mpubbise at codeaurora.org>
>> Signed-off-by: Venkateswara Naralasetty <vnaralas at codeaurora.org>
> 
> [...]
> 
>> --- a/drivers/net/wireless/ath/ath11k/wmi.c
>> +++ b/drivers/net/wireless/ath/ath11k/wmi.c
>> @@ -3366,6 +3366,10 @@ int ath11k_wmi_cmd_init(struct ath11k_base *ab)
>>  	config.rx_timeout_pri[2] = TARGET_RX_TIMEOUT_LO_PRI;
>>  	config.rx_timeout_pri[3] = TARGET_RX_TIMEOUT_HI_PRI;
>>  	config.rx_decap_mode = TARGET_DECAP_MODE_NATIVE_WIFI;
>> +
>> +	if (test_bit(ATH11K_FLAG_RAW_MODE, &ab->dev_flags))
>> +		config.rx_decap_mode = TARGET_DECAP_MODE_RAW;
> 
> Did you test this at all? Because to me it looks like in
> ath11k_init_wmi_config_ipq8074() this is overwritten with:
> 
> 	config->rx_decap_mode = TARGET_DECAP_MODE_NATIVE_WIFI;
> 
> So I can't see how this would even work. I noticed this while I was
> cleaning up ath11k_wmi_cmd_init(). I'll send a patch soon, please test
> that and let me know if it works.

My bad it seems my tree is bit older, sorry for the confusion.
Also I noticed, .wmi_init_config of ipq8074_ops is registered with " 
ath11k_init_wmi_config_qca6390()" Is that correct?
If that is correct,  then I don't see ath11k_init_wmi_config_ipq8074() 
is called from any other place.
I will send one patch to fix this issue. Please correct me if I am 
wrong.