[PATCHv2 1/2] nl80211: vendor-cmd: qca: add command for ap power save

[vnaralas at codeaurora.org]

On 2020-10-22 13:30, Arend Van Spriel wrote:
> On 10/21/2020 7:19 PM, Kalle Valo wrote:
>> vnaralas at codeaurora.org writes:
>> 
>>> On 2020-09-29 13:10, Kalle Valo wrote:
>>>> Johannes Berg <johannes at sipsolutions.net> writes:
>>>> 
>>>>> On Mon, 2020-08-24 at 13:56 +0530, Venkateswara Naralasetty wrote:
>>>>>> AP power save feature is to save power in AP mode, where AP goes
>>>>>> to power save mode when no stations associate to it and comes out
>>>>>> of power save when any station associate to AP.
>>>>> 
>>>>> Why do you think this requires a vendor command? I mean, that seems
>>>>> like
>>>>> fairly reasonable - even by default - behaviour?
>>>> 
>>>> I have not studied the details, but doesn't AP power save break 
>>>> normal
>>>> functionality? For example, I would guess probe requests from 
>>>> clients
>>>> would be lost. So there's a major drawback when enabling this, 
>>>> right?
>>> 
>>> This AP power save feature will not break any functionality, Since 
>>> one
>>> chain is always active and all other chains will be disabled when 
>>> this
>>> feature is enabled. AP can still be able to beacon and receive probe
>>> request from the clients. The only drawback is reduced network range
>>> when this feature is enabled. Hence, we don't want to enable it by
>>> default.
>> 
>> Yeah, we really would not want to enable that by default. But what
>> should be the path forward, a vendor command or a proper nl80211
>> command? Any opinions?
> 
> I would go for a proper nl80211 command or just add an attribute for
> use in NL80211_CMD_START_AP or deal with NL80211_CMD_SET_POWERSAVE
> when operating in AP mode.
> 
Sure, I will go with the existing NL80211_CMD_SET_POWERSAVE and I will 
send next version.

> Regards,
> Arend