[PATCH 1/2] dt: bindings: add new dt entry for ath11k calibration variant

Rob Herring robh at kernel.org
Mon Oct 19 17:18:50 EDT 2020


On Thu, 15 Oct 2020 15:15:00 +0200, Sven Eckelmann wrote:
> The bus + qmi-chip-id + qmi-board-id is not enough to identify the correct
> board data file on IPQ6018 based devices. Multiple different boards share
> the same values. Only the original reference designs can currently be
> identified and loaded from the board-2.bin. But these will not result in
> the correct calibration data when combined with the pre-calibration data
> from the device.
> 
> An additional "variant" information has to be provided to select the
> correct board data for a design which was modified by an ODM. This follows
> the same approach as ath10k.
> 
> Signed-off-by: Sven Eckelmann <sven at narfation.org>
> ---
>  .../devicetree/bindings/net/wireless/qcom,ath11k.yaml       | 6 ++++++
>  1 file changed, 6 insertions(+)
> 

Reviewed-by: Rob Herring <robh at kernel.org>



More information about the ath11k mailing list