[V2] ath10k-firmware: QCA9888 hw2.0: add GL.iNet GL-B2200 specific board file

Kalle Valo kvalo at kernel.org
Wed May 18 04:51:39 PDT 2022

Enrico Mioso <mrkiko.rs at gmail.com> writes:

> I would like to add a board file for the PCI-E Wi-Fi interface present
> on the GL.iNet GL-B2200 mesh router, a device added a while ago to
> OpenWRt.
> * Hardware description:
> This device seems based on IPQ4019 / AP-DK04.1-C3.
> Three radios are used:
> - one QCA4019 radio is used for 2.4 GHZ operation (submitted on a previous message)
> - one QCA4019 radio is used for 5 GHZ for operating on lower part of 5
> GHZ spectrum (submitted on a previous message)
> - a QCA9888V2 interface connected over PCI-E to operate on higher part
> of the 5 GHZ spectrum (contained in this message)
> * origin of the board files:
> The board file was provided by the manifacturer, who provided the
> original patch to support the device in OpenWRt.
> * ids to be used with the board files
> + bus=pci,bmi-chip-id=0,bmi-board-id=16,variant=GL-B2200
> SHA256: 7016cac25e5d35cf037f2f6aa63c03bd124fb521ec40c7843eb9d8424afa1a20
> * attached files:
> The names of the files are equal to the ID strings in the board-2.bin
> files, minus the .bin extension of course.

Thanks, added to QCA9888/hw2.0/board-2.bin:




1 board image(s) added, 0 changed, 0 deleted, 12 in total




More information about the ath10k mailing list