[PATCH] ath10k: do not enforce interrupt trigger type

[Steev Klimaszewski]

On 5/13/22 10:57 AM, Kalle Valo wrote:
> Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org> writes:
>
>> Interrupt line can be configured on different hardware in different way,
>> even inverted.  Therefore driver should not enforce specific trigger
>> type - edge rising - but instead rely on Devicetree to configure it.
>>
>> All Qualcomm DTSI with WCN3990 define the interrupt type as level high,
>> so the mismatch between DTSI and driver causes rebind issues:
>>
>>    $ echo 18800000.wifi > /sys/bus/platform/drivers/ath10k_snoc/unbind
>>    $ echo 18800000.wifi > /sys/bus/platform/drivers/ath10k_snoc/bind
>>    [   44.763114] irq: type mismatch, failed to map hwirq-446 for interrupt-controller at 17a00000!
>>    [   44.763130] ath10k_snoc 18800000.wifi: error -ENXIO: IRQ index 0 not found
>>    [   44.763140] ath10k_snoc 18800000.wifi: failed to initialize resource: -6
> So you tested on WCN3990? On what firmware version? I can add the
> Tested-on tag if you provide that.
>
Hello Krzystof, Kalle,

I have seen this issue as well on a Lenovo Flex 5G, which has a WCN3990:

wcn3990 hw1.0 target 0x00000008 chip_id 0x00000000 sub 0000:0000
kconfig debug 0 debugfs 0 tracing 0 dfs 0 testmode 0
firmware ver  api 5 features wowlan,mgmt-tx-by-reference,non-bmi crc32 
b3d4b790
htt-ver 3.86 wmi-op 4 htt-op 3 cal file max-sta 32 raw 0 hwcrypto 1

With this patch applied, I no longer see the error message in the commit 
message, when I unbind/bind when wifi stops working.

Tested-by: Steev Klimaszewski <steev at kali.org>

-- Steev