[PATCH 2/2] dt: bindings: ath10k: Document qcom, ath10k-pre-calibration-data-mtd

Christian Lamparter chunkeey at gmail.com
Fri Sep 18 12:53:35 EDT 2020

On 2020-09-18 18:29, Ansuel Smith wrote:
> Document use of qcom,ath10k-pre-calibration-data-mtd bindings used to
> define from where the driver will load the pre-cal data in the defined
> mtd partition.
> Signed-off-by: Ansuel Smith <ansuelsmth at gmail.com>

Q: Doesn't mtd now come with nvmem support from the get go? So
the MAC-Addresses and pre-caldata could be specified as a
nvmem-node in the devicetree? I remember seeing that this was
worked on or was this mtd->nvmem dropped?


More information about the ath10k mailing list