ath10k-firmware: QCA4019 hw1.0: Add OpenMesh A42 specific BDFs

[Kalle Valo]

Sven Eckelmann <sven.eckelmann at openmesh.com> writes:

> On Freitag, 26. Januar 2018 16:07:10 CET Kalle Valo wrote:
> [...]
>> > * bus=ahb,bmi-chip-id=0,bmi-board-id=16,variant=OM-A42
>> >   - sha256sum: 
>> >     10700a7ac636d57fe055e5bb4bd5f7bb3f1c282a7f25a8bb2204fc36e8c317bf
>> > * bus=ahb,bmi-chip-id=0,bmi-board-id=17,variant=OM-A42
>> >   - sha256sum:
>> >     b3d9556894e509ac608b2e27c9169da12c63634670bb69c5ef21fb31583e7998
>> 
>> I added these now:
>> 
>> https://github.com/kvalo/ath10k-firmware/commit/5cd2bacd8e22217335e539b416d0cb8d59f8e312
>>
>> To make this easier I did some bigger changes in ath10k-bdencoder,
>> please check carefully that I didn't break anything.
>
> Tested it by extracting the files using the ath10k-bdencoder d278f25bc977 
> (from 2017-02-10) and then calculating the sha256sum's using
>
>     $ sha256sum bus=ahb,bmi-chip-id=0,bmi-board-id=16,variant=OM-A42.bin bus=ahb,bmi-chip-id=0,bmi-board-id=17,variant=OM-A42.bin 
>     10700a7ac636d57fe055e5bb4bd5f7bb3f1c282a7f25a8bb2204fc36e8c317bf  bus=ahb,bmi-chip-id=0,bmi-board-id=16,variant=OM-A42.bin
>     b3d9556894e509ac608b2e27c9169da12c63634670bb69c5ef21fb31583e7998  bus=ahb,bmi-chip-id=0,bmi-board-id=17,variant=OM-A42.bin
>
> It was also checked that the board-2.json only had these names attached to the 
> .bin files.
>
> I did the same with my reference files and came to the same results. I am
> assuming that the files must have been added correctly when the names are 
> correct and the content is correct.
>
> I have then extracted the version prior to the OM-A42 change and compared it 
> to the one with OM-A42. The only difference I could find are related to the 
> OM-A42. I must therefore also assume that only the relevant parts were changed 
> and the other BDFs were not touched.

Good, thanks for checking!

-- 
Kalle Valo