[PATCHv3 1/2] ath10k: add per peer htt tx stats support for 10.4

[Kalle Valo]

Sven Eckelmann <sven.eckelmann at openmesh.com> writes:

> On Dienstag, 15. November 2016 22:07:29 CET akolli at qti.qualcomm.com wrote:
>> From: Anilkumar Kolli <akolli at qti.qualcomm.com>
>> 
>> Per peer tx stats are part of 'HTT_10_4_T2H_MSG_TYPE_PEER_STATS'
>> event, Firmware sends one HTT event for every four PPDUs.
>> HTT payload has success pkts/bytes, failed pkts/bytes, retry
>> pkts/bytes and rate info per ppdu.
>> Peer stats are enabled through 'WMI_SERVICE_PEER_STATS',
>> which are nowadays enabled by default.
>> 
>> Parse peer stats and update the tx rate information per STA.
>> 
>> tx rate, Peer stats are tested on QCA4019 with Firmware version
>> 10.4-3.2.1-00028.
>> 
>> Signed-off-by: Anilkumar Kolli <akolli at qti.qualcomm.com>
>
> Why is the support for 10.2.4 firmware not upstreamed? I mean the one which is 
> using pktlog to transfer the PEER_STATS information.

I'm not sure what you are asking. If you are asking the firmware release
mentioned in the commit log that's in ath10k-firmware:

https://github.com/kvalo/ath10k-firmware/tree/master/QCA4019/hw1.0/3.2.1

But I'm sure you know that already.

-- 
Kalle Valo