ath10k: MAC Address

[Sebastian Gottschall]

Am 20.02.2017 um 11:58 schrieb K.Mani:
> I'm using QCA8994, with PCIe bus the first two bytes of MAC address is
> returned as Null. This behavior is seen on all the 6 devices.
>
> log: wmi event ready sw_version 16777216 abi_version 3 mac_addr
> 00:00:79:55:a0:14
>
> Annapurna board(Alpine soc V1) on kernel-linux-3.10.20 openWRT
> FW: board-2.bin, firmware-5.bin
i ported this annapura device to dd-wrt. consider to use the correct 
board data for each indepenend wifi card
both board datas are stored in the "art" mtd partition, but you need to 
patch ath10k to use independend board data for each radio. otherwise the 
second radio will not work in 2.4 ghz

> Help needed.
>
> Thanks
> Mani
>
> _______________________________________________
> ath10k mailing list
> ath10k at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/ath10k
>


-- 
Mit freundlichen Grüssen / Regards

Sebastian Gottschall / CTO

NewMedia-NET GmbH - DD-WRT
Firmensitz:  Berliner Ring 101, 64625 Bensheim
Registergericht: Amtsgericht Darmstadt, HRB 25473
Geschäftsführer: Peter Steinhäuser, Christian Scheele
http://www.dd-wrt.com
email: s.gottschall at dd-wrt.com
Tel.: +496251-582650 / Fax: +496251-5826565