Issue with ATH10K driver with 802.11 a/g mode datarates

[Ben Greear]

Out of curiosity, does ath9k perform at the required rates in a similar
setup?

Sending tcp, udp, or some other protocol?  How are you generating the
traffic?

Thanks,
Ben

On 09/18/2016 09:26 PM, Sridhar Kondabathini wrote:
> Hi,
>
>      When we are testing 802.11 a/g mode throughput measurements on T1024RDB ( we used
> kernel-3.12; ath10k drivers backported from 4.4;hostapd 2.5 for 11AC support), then we
> are getting 26-27 Mbps , which is not meeting the required TEC specification (which is
> ~28 Mbps). How can we increase the throughput in these modes.
>
>       Can you please help on this.
>
>
>
> Regards,
>
> Sridhar Kondabathini,
> Research engineer,
> PSG lab,
> Center for Development Of Telematics
> 9480484821.
>
>
>
>
> Disclaimer:
> ----------
> This email and any files transmitted with it are confidential and intended solely
> for
> the use of the individual or entity to whom they are addressed.  If you are not the
> intended recipient you are notified that disclosing, copying, distributing or taking
> any
> action in reliance on the contents of this information is strictly prohibited. The
> sender does not a
>
>
> _______________________________________________
> ath10k mailing list
> ath10k at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/ath10k
>


-- 
Ben Greear <greearb at candelatech.com>
Candela Technologies Inc  http://www.candelatech.com