[PATCH] QCA9984 VHT160 support
s.gottschall at dd-wrt.com
Tue Oct 18 02:16:49 PDT 2016
i've seen you added a new firmware for 9984. is there anything you can
tell about already?
Am 18.10.2016 um 10:20 schrieb Sebastian Gottschall:
> Am 14.10.2016 um 12:14 schrieb Valo, Kalle:
>> Sebastian Gottschall <s.gottschall at dd-wrt.com> writes:
>>> This patch adds full VHT160 support for QCA9984 chipsets
>>> Tested on Netgear R7800. 80+80 is possible, but disabled so far since
>>> it seems to contain glitches like missing vht station flags (this may
>>> be firmware or mac80211 related)
>> So how did you disable 80+80 exactly? I can't find it and I would like
>> to add a comment to the code so that it's easy to enable it later (once
>> it's working).
> IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160MHZ =vht160 only
> IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160_80PLUS80MHZ = vht160 and 80+80
> + if ((ar->vht_cap_info & IEEE80211_VHT_CAP_SHORT_GI_160) &&
> + !(ar->vht_cap_info &
> + vht_cap.cap |= IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160MHZ;
> so if the firmware itself doesnt contain the correct vht flags but
> just short_gi_160 flag. i assume it supports vht160 and set the vht160
> only flag.
> newer firmwares on codeaurora contain the correct flags. so this code
> here gets avoided. unfortunatly the newer i found is also not stable
> and crashes often.
> you can also enable 80+80 support with the current firmware.but all
> station ht and vht flags seem to be empty then in vht160 mode too. so
> it might be a firmware issue still with 80+80 or mac80211.
> i did not debug that much. but vht160 works. i also tested it now with
> a 88w6964 marvell client in vht160 which worked too
Mit freundlichen Grüssen / Regards
Sebastian Gottschall / CTO
NewMedia-NET GmbH - DD-WRT
Firmensitz: Berliner Ring 101, 64625 Bensheim
Registergericht: Amtsgericht Darmstadt, HRB 25473
Geschäftsführer: Peter Steinhäuser, Christian Scheele
email: s.gottschall at dd-wrt.com
Tel.: +496251-582650 / Fax: +496251-5826565
More information about the ath10k