802.11s channel width settings?

[Yeoh Chun-Yeow]

Try use the "iw wlanX station dump" and check the rx bitrate.

----
Chun-Yeow

On Fri, May 6, 2016 at 10:28 PM, Zach Sherin <zach at netblazr.com> wrote:
> That is embarrassing that I trusted OpenWRT to have tried that. It
> would appear that I can set the frequency manually. Thank you!
>
> On a related note, is there any way to check the modulation that the
> radio is using?  I'd like to check all the parameters possible in
> order to understand my throughput numbers.
>
> Thanks again for the fix!
> Zach
>
> On Thu, May 5, 2016 at 9:32 PM, Bob Copeland <me at bobcopeland.com> wrote:
>> On Thu, May 05, 2016 at 02:51:27PM -0400, Zach Sherin wrote:
>>> Is there any way to increase channel widths in 802.11s? If this is an
>>> OpenWRT question and not ath10k I'll head over to the forums, but this
>>> seemed more a driver issue as my wireless config requests wide
>>> channels. Any chance there's a specific version of ath10k I should
>>> push to?
>>
>> I'm not sure about OpenWRT's scripts but you can specify the channel width
>> when setting the frequency (before joining the mesh).
>>
>> E.g.:
>>
>> ip link set wlan0 up
>> iw dev wlan0 set freq 5745 80 5775
>> iw dev wlan0 mesh join my-vht-mesh
>>
>> --
>> Bob Copeland %% http://bobcopeland.com/
>
> _______________________________________________
> ath10k mailing list
> ath10k at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/ath10k