[PATCH 1/3] ath10k: fix calibration init sequence of qca99x0

[Rajkumar Manoharan]

pre-calibration is meant for qca4019 which contains only caldata
whereas calibration file is used by ar9888 and qca99x0 that contains
both board data and caldata. So by definition both pre-cal-file and
cal-file can not coexist. Keeping them in shared memory (union), is
breaking boot sequence of qca99x0. Fix it by storing both binaries
in separate memories. This issue is reported in ipq8064 platform which
includes caldata in flash memory.

Reported-by: Sebastian Gottschall <s.gottschall at dd-wrt.com>
Signed-off-by: Rajkumar Manoharan <rmanohar at qti.qualcomm.com>
---
 drivers/net/wireless/ath/ath10k/core.h | 6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)

diff --git a/drivers/net/wireless/ath/ath10k/core.h b/drivers/net/wireless/ath/ath10k/core.h
index b6c157e..a7d04bc 100644
--- a/drivers/net/wireless/ath/ath10k/core.h
+++ b/drivers/net/wireless/ath/ath10k/core.h
@@ -725,10 +725,8 @@ struct ath10k {
 	const void *firmware_data;
 	size_t firmware_len;
 
-	union {
-		const struct firmware *pre_cal_file;
-		const struct firmware *cal_file;
-	};
+	const struct firmware *pre_cal_file;
+	const struct firmware *cal_file;
 
 	struct {
 		const void *firmware_codeswap_data;
-- 
2.7.4